- MASTERCAM X5 LATHE TRAINING TUTORIAL MANUAL
- MASTERCAM X5 LATHE TRAINING TUTORIAL SOFTWARE
- MASTERCAM X5 LATHE TRAINING TUTORIAL WINDOWS
This tutorial takes approximately 50 minutes to complete. Running the Verify to simulate the tool cutting from the solid model. Running the Backplot to see the path the tool takes to cut the part. The Student will simulate the toolpaths using Mastercam's Verify and Backplot by: Defining a 3-dimensional cylinder the size of the workpiece. Cutoff toolpath to cut the part off at a desired position. Grooving at an angle with fillets in the corners of the groove Finishing toolpath with multiple passes using a tool with a round insert. Canned Finish toolpath to remove the leftover material from the roughing toolpath. Canned Roughing toolpath to remove the bulk of material. The Student will create lathe toolpaths consisting of: Facing toolpath to machine the face of the part. Use the trim divide command to clean up the geometry. Using the arc tangent command to create tangent arcs. Creating arcs using the create circle center point command. Trim lines using the distance option in the Trim/Break/Extend command. Use the Create Line Perpendicular command to create lines. Trim the construction lines using Trim 2 Entities command. TUTORIAL #3Objectives:The Student will design a 2-dimensional drawing by: Create lines using polar positioning. General Notes.B-1 Creating a Lathe Tool Library.C-1 Editing a Lathe Tool Library.D-1 Quiz Answers. Lathe Training Tutorial ContentsGetting Started.
MASTERCAM X5 LATHE TRAINING TUTORIAL WINDOWS
Windows, Windows XP, Windows Vista and Windows NT are registered trademarks of Microsoft Corporation. Microsoft, the Microsoft logo, MS, and MS-DOS are registered trademarks of Microsoft Corporation NSee is a registered trademark of Microcompatibles, Inc. Trademarks Mastercam is a registered trademark of CNC Software, Inc. This document may not, in whole or part, be copied, photographed, reproduced, translated or reduced to any electronic medium or machine readable form without prior consent, in writing, from In-House Solutions Inc.
MASTERCAM X5 LATHE TRAINING TUTORIAL MANUAL
Copyrights This manual is protected under International copyright laws. Some jurisdictions do not allow the exclusion or limitation of implied warranties or liability for incidental or consequential damages, so the above limitation or exclusion may not apply to you. has been advised of the possibility of such damages.
be liable for direct, indirect, or consequential damages resulting from any defect in the manual, even if In-House Solutions Inc. Should the manual prove defective following its purchase, the buyer (and not In-House Solutions Inc., its distributer, or its retailer) assumes the entire cost of all necessary servicing, repair, of correction and any incidental or consequential damages. manual is sold or licensed "as is." The entire risk as to its quality and performance is with the buyer.
MASTERCAM X5 LATHE TRAINING TUTORIAL SOFTWARE
makes no warranties, either express or implied, with respect to this manual or with respect to the software described in this manual, its quality, performance, merchantability, or fitness for any particular purpose. Disclaimer Of All Warranties And Liability In-House Solutions Inc.
reserves the right to make improvements to this manual at any time and without notice. All rights reserved Software: Mastercam X5 Author: Mariana Lendel ISBN: 978-1-92 Revision Date: OctoNotice In-House Solutions Inc. Mastercam X5 Lathe Training Tutorial Copyright: 1998 -2010 In-House Solutions Inc. To order more books: Call 1-80 or Visit or Contact your Mastercam dealer
0 kommentar(er)
